Question

State the difference between positive and negative zero error of a screw gauge.

February 4, 2024

Measurement Class 9 ICSE

Answer

If on bringing the flat end of the screw in contact with the stud, the zero mark on the circular scale is below the base line of the main scale, the zero error is said to be positive and if the zero mark on the circular scale is above the base line of the main scale, the zero error is said to be negative.

Was this answer helpful?

Didn't liked the above answer ?

Text Generation Tool

💡 Some Related Questions

How much time does the bob of a seconds’ pendulum take to move from one extreme of its oscillation to the other extreme?

It takes 0.2s for a pendulum bob to move from mean position to one end. What is the time period of pendulum?

The time periods of two simple pendulums at a place are in the ratio 2:1. What will be the ratio of their lengths ?

A pendulum completes 2 oscillations in 5s. (a) What is its time period? (b) If g = 9.8 ms-2, find its length.

Compare the time periods of two pendulums of length 1m and 9m

Find the length of a seconds’ pendulum at a place where g = 10 ms-2 (Take π = 3.14).

A seconds’ pendulum is taken to a place where acceleration due to gravity falls to one forth. How is the time period of the pendulum affected, if at all? Give reason. What will be its new time period?

The time period of a simple pendulum is 2s. What is its frequency? What name is given to such a pendulum?

A simple pendulum completes 40 oscillations in one minute. Find its (a) frequency, (b) time period.

How does the time period (T) of a simple pendulum depend on its length (l) ? Draw a graph showing the variation of T² with l. How will you use this graph to determine the value of g (acceleration due to gravity)?

error: Content is protected !! 💀