ICSEClass XPhysicsCurrent Electricity01 Mark2024 Easy

QQuestion

The specific resistance of a wire depends on:

(a) its length

(b) the material of the wire

(c) its cross-sectional area

(d) its radius

Exam-ready answer 01 Mark

Answer

(b) the material of the wire

Explanation:

Specific resistance is a property of the material and, at a given temperature, does not depend on the dimensions of the wire.

Was this answer helpful?

Related Questions

More ICSE Easy level questions

1/12

The potential difference between the terminals of a cell in a closed circuit is called: (a) terminal voltage (b) electromotive force (c) voltage drop (d) none of these

Easy 01 Mark

5 bulbs are connected in series in a room. One bulb is fused. It is removed and remaining 4 bulbs are again connected in series to the same circuit. What will be the effect on the following physical quantities? (Increases, Decreases, Remain Same) (a) Resistance (b) Intensity of light

Easy 02 Mark

Study the diagram: (a) Calculate the total resistance of the circuit. (b) Calculate the current drawn from the cell. (c) State whether the current through 10 Ω resistor is greater than, less than or equal to the current through the 12 Ω resistor.

Easy 03 Mark

The voltage-current readings of a certain material are shown in the table given below: Voltage (V) Current (I) 10 V 2 A 20 V 3 A 30 V 4 A Study the table. (a) State whether the conductor used is ohmic or non-ohmic. (b) Justify your answer. (c) State Ohm’s law.

Easy 03 Mark

When a current I flows through a wire of resistance R for time t then the electrical energy produced is given by: (a) I2Rt (b) IR2t (c) IRt (d) IRt2

Easy 01 Mark

Choose the correct relation for e.m.f. (ε) and terminal voltage V: (a) ε = V [always] (b) V > ε [always] (c) V < ε [when the cell is in use] (d) None of these

Easy 01 Mark

In the given circuits Y and Z, the resistors, R₁ and R₂, are connected in : (a) series in both the circuits (b) parallel in both the circuits (c) parallel in Y and series in Z (d) series in Y and parallel in Z

Easy 01 Mark

In a closed circuit containing a bulb and a cell, the electromotive force (ε) and the terminal voltage (V) is related as. (Given I is current and r is internal resistance.) (a) V = ε + Ir (b) V = ε – Ir (c) V = ε ÷ Ir (d) V = ε × Ir

Easy 01 Mark

(a) Define specific resistance. (b) What happens to the specific resistance of a conductor if its length is doubled? (c) Name a substance whose specific resistance remains almost unchanged with the increase in its temperature.

Easy 03 Mark

Find the value of current I drawn from the cell. (a) Calculate the current I. (b) Calculate the terminal voltage.

Easy 04 Mark

Three identical bulbs B1, B2 and B3, each of power rating 18 W, 12 V, are connected to a battery of 12 V as shown. (a) Calculate: (i) the resistance of each bulb (ii) the current drawn from the cell (b) If bulb B3 is removed from the circuit, will the brightness of bulb B1 increase, decrease or remain the same?

Easy 04 Mark

Complete the following by choosing the correct answers from the bracket: (a) In uniform circular motion the centrifugal force acts ............... [towards the centre/away from the centre/along the tangential direction]. (b) Refractive index of a medium is independent of ............... [temperature/angle of incidence/wavelength of light]. (c) Heat absorbed during change of phase depends on ............... [mass/change in temperature/specific heat capacity] of the substance. (d) Emf of a cell is ............... [greater than/less than/equal to] the terminal voltage when the cell is in open circuit. (e) In a step-up transformer the turns ratio is ............... [more than 1/less than 1/equal to 1]. (f) The nuclear radiation with lowest ionising power is ............... [α/β/γ].

Easy 06 Mark