QQuestion
A fuse is rated 5 A. Can it be used with a geyser rated 1540 W, 220 V. Write Yes or No. Give supporting calculations to justify your answer.
✓Answer
Maximum current passing through the fuse (Imax) = 5 A
Input voltage of the geyser (V) = 220 V
Power rating of the geyser (P) = 1540 W
Let, current passing through geyser be I.
Then, P = IV
I = \frac{P}{V} = \frac{1540}{220} = 7 A
As, Imax = 5 A < I = 7 A
So if the fuse is used with the geyser then it will draw more current greater than the maximum current and in turn fuse will melt.
No, the fuse can not be used with the geyser.
Related Questions
More ICSE Easy level questions
Identify the option that displays the correct wiring with correct colour code: (a) (b) (c) (d)
According to the NEW colour convention which colour of wire is connected to: (a) the metal body of the appliance (b) the switch of the appliance?
(a) Which electrical component protects the electric circuit in case of excess current and which can also be used as a switch? (b) Name the wire to which this electrical component is connected in an electric circuit.
The diagram shows wiring in a meter room of a building. (a) What is the current rating of device X? (b) What is the difference between switch Z shown in the diagram and the switches used to operate different appliances at home? (c) What is the unit of the physical quantity displayed in Y?
An electric iron rated 1100 W, 220 V is operated for 5 hours. Calculate: (a) the minimum rating of the fuse required. (b) the energy consumed in kWh. (c) the cost of the energy consumed, if the rate is ₹10 per unit.
The reverse side of a three-pin plug with incorrect connection of wires is shown below. (a) Identify the fault in the above connection. (b) Mention a risk factor involved if the user operates the appliance without correcting it. (c) Will the appliance function in the present situation? (Yes or No)
(a) State one factor that affects the magnitude of induced current in an AC generator. (b) Given below is a circuit to study the magnetic effect of electric current. ABCD is a cardboard kept perpendicular to the conductor XY. A magnetic compass is placed at the point P of the cardboard. P1 and P2 are the positions of the magnetic compass, before and after passing a current through XY respectively. (i) Name the rule that is used to predict the direction of deflection of the magnetic compass. (ii) State the direction of current in the conductor (X to Y or Y to X) when the circuit is complete. (iii) If resistance R is increased, then what will be the effect on the magnetic lines of force around the conductor?
85 g of water at 30°C is cooled to 5°C by adding certain mass of ice. Find the mass of ice required. [Specific heat capacity of water = 4.2 J g−1 °C−1, Specific latent heat of fusion = 336 J g−1]
Given are two pulleys. (a) Copy and complete the labelled diagram connecting the two pulleys with a tackle to obtain Velocity Ratio = 2. (b) If Load = 48 kgf and efficiency is 80% then calculate: (i) Mechanical Advantage. (ii) Effort needed to lift the load.
(a) Define Centre of Gravity. (b) A hollow ice cream cone has height 6 cm. (i) Where is the position of its centre of gravity from the broad base? (ii) Will its position change when it is filled completely with honey? Write Yes or No.
Light travels a distance of ‘10x’ units in time ‘t1’ in vacuum and it travels a distance of ‘x’ units in time ‘t2’ in a denser medium. Using this information answer the question that follows: (a) ‘Light covers a distance of ‘20x’ units in time ‘t1’ in diamond.’ State true or false. (b) Calculate the refractive index of the medium in terms of ‘t1’ and ‘t2’.
Study the diagram: (a) Calculate the total resistance of the circuit. (b) Calculate the current drawn from the cell. (c) State whether the current through 10 Ω resistor is greater than, less than or equal to the current through the 12 Ω resistor.