ICSEClass XPhysicsForce01 Mark2025 Easy

QQuestion

Which among the following is a vector quantity?

(a) work

(b) power

(c) energy

(d) moment of couple

Exam-ready answer 01 Mark

Answer

(d) moment of couple

Explanation:

A couple has both magnitude and direction, making it a vector quantity. Its direction is perpendicular to the plane in which the two forces lie. Its magnitude is calculated by multiplying one of the forces by the perpendicular distance between their lines of action.

Was this answer helpful?

Related Questions

More ICSE Easy level questions

1/12

A body is acted upon by two equal and opposite forces, that are NOT along the same straight line. The body will : (a) remain stationary (b) have only rotational motion (c) have only rectilinear motion (d) have both rectilinear and rotational motion

Easy 01 Mark

A non-uniform kite is hanging freely from the branch of a tree as shown. Study the figure and answer the following: (a) Fill in the blank. ............... [P, Q, R or S] is the most probable position of its centre of gravity. (b) Support your answer to (a) with a reason.

Easy 02 Mark

Complete the following by choosing the correct answers from the bracket: (a) In uniform circular motion the centrifugal force acts ............... [towards the centre/away from the centre/along the tangential direction]. (b) Refractive index of a medium is independent of ............... [temperature/angle of incidence/wavelength of light]. (c) Heat absorbed during change of phase depends on ............... [mass/change in temperature/specific heat capacity] of the substance. (d) Emf of a cell is ............... [greater than/less than/equal to] the terminal voltage when the cell is in open circuit. (e) In a step-up transformer the turns ratio is ............... [more than 1/less than 1/equal to 1]. (f) The nuclear radiation with lowest ionising power is ............... [α/β/γ].

Easy 06 Mark

Akash takes a uniform metre scale and suspends a weight of 2 N at one end ‘X’, and a weight of 5 N on the other end ‘Y’. He then balances the ruler horizontally on a knife edge placed at 70 cm from X. Draw a diagram of the arrangement and calculate the weight of the ruler.

Easy 03 Mark

Clockwise moment produced by a force about a fulcrum is considered to be: (a) Positive (b) Negative (c) Zero (d) None of these

Easy 01 Mark

A door lock is opened by turning the lever (handle) of length 0.2 m. If the moment of force produced is 1 Nm, then the minimum force required is: (a) 5 N (b) 10 N (c) 20 N (d) 0.2 N

Easy 01 Mark

When a bell fixed on a cycle rings, then the energy conversion that takes place is: (a) gravitational potential energy to sound energy (b) kinetic energy to sound energy (c) sound energy to electrical energy (d) sound energy to mechanical energy

Easy 01 Mark

For a body to be in dynamic equilibrium: (a) its momentum must be zero (b) its acceleration must be zero (c) its kinetic energy must be zero (d) its velocity must be zero

Easy 01 Mark

A metre scale of weight 50 gf can be balanced at 40 cm mark without any weight suspended on it. (a) If this ruler is cut at its centre then state which part [0 to 50 cm or 50 to 100 cm] of the ruler will weigh more than 25 gf. (b) What minimum weight placed on this metre ruler can balance this ruler when it is pivoted at its centre?

Easy 03 Mark

The diagram shows wheel O pivoted at point A. Three equal forces F1, F2 and F3 act at point B on the wheel. (a) Which force will produce maximum moment about A? (b) Give a reason for your answer in (a).

Easy 02 Mark

(a) What is the position of centre of gravity of a triangular lamina? (b) When this triangular lamina is suspended freely from any one vertex, what is the moment of force produced by its own weight in its rest position?

Easy 02 Mark

A non-uniform beam of weight 120 N pivoted at one end is shown in the diagram below. Calculate the force F required to keep the beam in equilibrium.

Easy 02 Mark